Peugeot 308 Key Fob Replacement
Peugeot's 308 may be a bit old, but it is still eye-catching. peugeot replacement key fob 's not the most luxurious car in its class It's it's a Ford Focus or Volkswagen Golf will shield you from surface imperfections - but it's a relaxing and a civilized drive.
We often get asked at Coded Car Keys to replace peugeot key fobs. No matter if the issue is constant or intermittent the following tips will aid.
Water Damage
When you accidentally leave your key fob in a puddle or get it wet when kayaking, swimming, canoeing, rafting, or canyoning, it's more likely to suffer water damage. Keep your key fob in a dry, dry bag each time you go outside or engage in activities that expose it to a lot of water.
You should also ensure that the fob is dry prior to opening it and reusing it. If you detect any odors from the fob (such as industrial fluid or windshield washer fluid), this is another indicator that it is submerged.
A circuit board that's wet can cause the battery to discharge its energy or even explode. If you can remove your keyfob 308 from the water and turn it upside up and shake as much water as you can before opening the casing. Take the battery out, and then clean the circuit board using a cotton swab that has been dipped in 90-percent alcohol.
Other reasons your Peugeot 308 remote keyless entry system could be unable to function could be due to an empty coin battery problems with the receiver module, signal interference, or a faulty electronic chip. If none of these are the reason it is possible to reset the system by removing the 12 volt battery from the car for 15 mins.
Dead Coin Battery
Peugeot cars are equipped with a remote-start feature that allows the driver to start the car from a distance, warming up or cooling down the car prior to entering. This feature is very useful particularly in cold winter months. The remote start system can stop working for a variety reasons, such as a dead coin-battery.
A coin-shaped battery that is located inside the key fob has a life span of two to four years, depending on how frequently it is used and where it is purchased. The date of use is printed on the package or marked in the user's manual.
If the key fob stops working after being exposed water that is clean, remove the battery and clean the electronic chip with a paper towel soaked in isopropyl ethanol. Then, dry the chip thoroughly before replacing. If you expose it to salty or soapy water, the chip may be fried and you will need to replace the key fob entirely.
If you're unsure whether the battery is damaged it is possible to check the voltage using an instrument connected to the minus and plus terminals. The voltage should be around 12-13 volts but if it is lower, the battery must be replaced. You can also try to reset your on-board computer by disconnecting the 12 volt battery for a few minutes and then reconnecting it in reverse order (positive cable first and then negative). The engine should begin to run after this.
Faulty Receiver Module
If you don't see "Key Detected" you might find that your receiver module is not working properly. It's that part that sends an indication to the car when your key fob is activated it also acts as an immobiliser. It stops it from starting until the correct key is used.
This could be due to a range of reasons, including water damage or simply ageing. If the electronic chip in your Peugeot 308 keyfob has been damaged by dirty tap water it could be because the keyfob was in contact with it. In this situation, you'll need to take off the battery and clean it thoroughly with isopropyl alcohol or electronic cleaner. When the battery is clean you can try it again.
If the issue is not resolved, it is recommended to see an area Peugeot expert or locksmith. They'll be able to use a diagnostic tool to help pinpoint the issue and repair it for you.
Losing your Peugeot keys to your car is an extremely stressful experience. A qualified auto locksmith can resolve the issue within minutes. They can program your vehicle and cut a brand new, working key for you. Click here to find a locksmith in your area.
Electronic chip that is malfunctioning
The electronic chip inside your Peugeot 308 key fob is a very important component of the remote control system. If the chip is damaged, you may experience difficulties starting your vehicle or receive a message saying "anti-theft". If this happens, the only way to fix the issue is to purchase a new key. Auto locksmiths who are professionals can provide this service within the shortest possible time.
The chip inside your Peugeot 308's key fob could be damaged due to a variety of reasons, including sweat, water damage, or dirt. If your Peugeot key fob was exposed to soapy or dirty water, it should be cleaned immediately. You can clean the electronic component with the help of a towel that is soaked in isopropyl Alcohol. After that, allow the battery to dry completely.
Radio interference can cause a key fob's functionality to cease. This can happen when other devices use the same frequency as your Peugeot keyfob. This could be due to poor conditions or objects near to the vehicle. It is recommended that you visit a Peugeot dealer if you encounter this issue.
The Peugeot 207/308 Key Fob is delicate and needs particular care. You should not drop it or throw it around. If you lose something, try to locate it as soon as possible. You can reset all the on-board computers by disconnecting the battery that is 12 volts for a few minutes. Make sure you disconnect the negative first, and then the positive.